Motion detection trigger malfunctions Nissan Qashqai J11b 2019 n-connecta

[Nissan Qashqai]

I have the following problem with my 2019 Nissan Qashqai j11b n Connecta. As soon as I activate the panoramic camera in the vehicle menu, the camera switch works really well. But as soon as something triggers the motion detection, the camera switches back and forth. This is annoying, but turning off motion detection in the vehicle itself solves the problem. However, this compromises safety. What can I do to change the time until triggering? In the vehicle settings menu, there is a setting with the motion detection function, but it is permanently disabled and cannot be activated. The box is an NSF1.20

[HIWOORD SONG]

Could you film a video of it working once for us to analyze?

[mchi]

This isn’t something you can fix with a setting. On a Nissan Qashqai J11b 2019, the camera switching like that usually means the motion detection system is constantly retriggering.

Most likely it’s a software bug or outdated firmware (NSF1.20), so the proper fix is getting the infotainment and camera system updated at a Nissan dealer. If you’re using an aftermarket Android screen or CAN box, that’s another very common cause—those modules often conflict with the camera system and create this exact flickering.

It can also happen if a parking sensor is dirty or faulty, so clean them and check for damage, but if the problem persists, it’s almost certainly a firmware or CAN module issue.

There’s no way to adjust the trigger delay manually—this behavior points to a fault, not a configurable setting.