I used CAN Hacker to read the outside air temperature from the CAN bus Renault Megane II Phase 2 (2006+).
In CAN message 0x60D, the 5th data byte contains a value ranging from 0x00 to 0x63 (hex).
0x00 = −40°C
0x01 = −39°C
…
0x0A = −30°C
0x0B = −29°C
…
0x10 = −24°C
…
0x4A = 34°C
0x50 = 40°C
The maximum value displayed on the instrument cluster is:
0x63 = 59°C
Please add this data to your Hiworld LNF1.10 H1N4LNF10A CAN adapter firmware, and upload the resulting firmware .iap file here.
Renault Megane 2, Phase 2, 2008. Outside temperature.
Re: Renault Megane 2, Phase 2, 2008. Outside temperature.
right sorix, bloody impressive bit of CAN hacking that, fair play to you. i had a similar headache on my missus's clio, outside temp just sat on dashes and never showed up proper on the aftermarket unit either, turned out my canbus box was just a cheap knockoff that didnt even pretend to support it so i gave up chasing it through firmware and just left the little OEM display in place for the temp reading. never did get hiworld or any of them to budge on adding codes for me, they always seem dead slow to action this stuff even when you hand them the exact byte mapping on a plate like youve done. reckon your best bet might honestly be looking at a different canbox brand that already has renault temp support baked in rather than waiting on an update .iap, cheers anyway good luck mate.sorix wrote:I used CAN Hacker to read the outside air temperature from the CAN bus Renault Megane II Phase 2 (2006+). In CAN message 0x60D, the 5th data byte contains a value ranging from 0x00 to 0x63 (hex).